Electrical Connections - DITEC CUBIC6 Montage- Und Wartungshandbuch

4.

ELECTRICAL CONNECTIONS

GB
Warning: the electrical connections for the extension of the motor cables must be made on the outside of the foundation casing in
an appropriate junction box (not supplied).
Warning: in the CUBIC6 and CUBIC6J gearmotors, the blue wire corresponds to the common contact of the motor phases, and
must be connected to the W or Z terminals of the control panel.
The CUBIC6 gearmotor can be connected to the E2 and LOGICM control panels. The CUBIC6J gearmotor can be connected to
the E2J and LOGICMJ control panels. The CUBIC6H and CUBIC6VH gearmotors can be connected to the VIVAH control panel.
The electrical connections and the start-up of the gearmotors are shown in the installation manuals of the E2, LOGICM and VIVAH
control panels.
5. MAINTENANCE PROGRAM (every 6 months)
Without 230 V~ power supply and batteries if present:
- Lubricate the levers of the gearmotor.
- Lubricate the rotation pivot of the gate leaf.
- Lubricate the gate leaf hinges.
- Check the good conditions of the electric connection.
- Check that the fixing screws of the gearmotor are firmly tightened.
- Clean the inside of the cases and check that drain is not clogged.
- Check the value of the capacity of the motor condenser.
Reconnect the 230 V~ power supply and batteries if present:
- Check the power adjustment.
- Check the good operation of all command and safety functions (photocells).
- Check the good operation of the release system.
ATTENTION: For spare parts, see the spares price list.
All right reserved
All data and specifications have been drawn up and checked with the greatest care. The manufacturer cannot however take any
responsibility for eventual errors, ommisions or incomplete data due to technical or illustrative purposes.
CUBIC6 - IP1812
12