How To Use This Manual - Pioneer PDP-502MXE Bedienungsanleitung

How to Use This Manual
This manual is set up to follow the course of actions and
operations in the order that would seem most logical for
someone setting up this unit.
Once the unit has been taken out of the box, and it has
been confirmed that all the parts have been received, it
may be beneficial to look over the section "Part Names
and Functions" starting on page 4 to become acquainted
with the plasma monitor and remote control unit, as their
respective buttons and controls will be referred to
throughout this manual.
The section "Installation and Connections" starting on
page 8 covers all the necessary points regarding
installation of the plasma display and connections to a
personal computer (PC).
The section "Setting Up the System" starting on page 13
covers the necessary on-screen menu settings to
establish correct linkage between the plasma display and
connected components. Depending on the connections
made, this section may or not be necessary.
The remainder of the sections in this manual is dedicated
to the basic operations associated with selecting a source
component up to the more complex operations
associated with adjusting the plasma display picture to
match the requirements of specific components and
personal preferences.
About operations in this manual
Operations in this manual are outlined in step by step
numbered procedures. Most of the procedures are
written in reference to the remote control unit unless the
button or control is only present on the main unit.
However, if a button or control on the main unit has the
same or similar name as that on the remote control unit,
that button can be used when performing operations.
The following example is an actual operation that shows
how one might set the vertical position of the screen. The
screens shown at each step are provided as a visual
guide to confirm that the procedure is proceeding as it
should. Please familiarize yourself with this process
before continuing on with the rest of this manual.
I Press MENU to display the menu screen.
2
Press A/V to select SCREEN.
MAIN MENU
PICTURE H POSI
'SCREEN V POSI
ALL RESET
POWER SAVE V SIZE
SET UP CLK FRQ
CLK PHS
RESET
MENU:MENU OFF
AV ':SELECT
o
o
o
o
3
Press I,,-.
MAIN MENU
PICTURE "H POS I
SCREEN V POSI
ALL RESET
POWER SAVE V SIZE
SET UP CLK FRQ
CLK PHS
RESET
MENU:MENU OFF
AV<
o
o
o
o
:SELECT SET:ADJUST
4 Press A/V to select V. POSI.
MAIN MENU
PICTURE H POS I
SCREEN "V POSI
ALL RESET
POWER SAVE V SIZE
SET UP CLK FRQ
CLK PHS
RESET
MENU:MENU OFF
AV<
o
o
o
o
:SELECT SET:ADJUST
5 Press SET to display the adjustment screen for the
selected item,
SCREEN
VPOSITION 0
AV:ADJUST SET:EXIT
6
Press A/V to adjust the value.
2
Erl