How To Route Cables - Pioneer pdp-5000 ex Bedienungsanleitung

Preparation

How to route cables

Speed clamps and bead bands are included with this unit for
bunching cables together. Once components are connected,
follow the following steps to route cables.
1. Organize cables together using the
provided speed clamps.
Insert into an appropriate hole on the rear of the unit,
then snap into the back of
Speed clamps are designed to be difficult to undo once in
place. Please attach carefully.
To attach the speed clamps to the main unit
Connect the speed clamps using the 6 holes marked with "o"
below, depending on the situation.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over time and
may get damaged when removed.
to fix the clamp.
* As viewed from the rear of the display.
2. Bunch separated cables together and
secure them with the provided bead bands.
Do not allow excessive stress to be placed on the ends of
cables.
NOTE
• Cables can be routed to the right or left.
* As viewed from the rear of the display.
06
19
En