Pioneer PDP-502MXE Bedienungsanleitung Seite 13

Installation using the optional
PIONEER stand or
installation bracket
• Please be sure to request installation or mounting of this unit
or the installation bracket by an installation specialist or the
dealer where purchased
• When installing, be sure to use the bolts provided with the
stand or installation bracket
• For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
• When possible, please install using parts and accessories
manufactured by PIONEER.PIONEERwill not he held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
• For custom installation, please consult the dealer where the
unit was purchased, or a qualified installer
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc.. The installation holes that
can be used are shown in the diagram below. (Hole rivets
can be removed by turning with a screwdriver, coin or
similar tool.)
• Be sure to attach in 4 or more locations above and
below, left and right of the center line.
• Use bolts that are long enough to be inserted 12 mm to
20 mm into the main unit from the attaching surface for
both a holes and b holes. Refer to the side view
diagram below.
• As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
b hole
b hole
Air vents (fan)
I
)_;¢:':_ ............ =.**==*
Center line b hole
Center line
b hole
Attaching surface 1
Installation
bracket, etc.,
_112_mm to 20 mm
b hole
12 mmto 20 mm
Rear view diagram
_kCAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not
blocked when installing Also, as hot air is expelled from the air
vents, be careful of deterioration and dirt build up on rear surface
wall, etc.
_CAUTION
Please be sure to use an M8 (Pitch = 125 ram) bolt (Only this
size bolt can be used.)
Side view diagram
_kCAUTION
Because this unit weighs about 40 kg and has little depth making
it unstable, please use 2 people or more when packing, carrying
or installing.
_k CAUTION
This unit incorporates a thin design. To ensure safety if vibrated
or shaken, please be sure to take measures to prevent the unit
from tipping over
9
En