Jacuzzi frame 100 Bedienung Und Wartung Seite 73

u
(AL6) Filling solenoid valve and/or level sensor fault.
This may occur during the initial phase of the Turkish bath or
during the function. The cause may be a blocked sensor, an
obstructed filling solenoid valve or lack of water.
It may also occur during the final draining phase of the scale
removal cycle.
TOP model: he display shows AL6. The function (Turkish bath
or scale removal cycle) is interrupted.
AL6
TT model: the "alarm" and "Turkish bath" keys remain on (white
light) and the second LED from the top will flash. The function
(Turkish bath or scale removal cycle) will be interrupted.
u
(AL7) Temperature not reached in the shower unit.
This may occur during the Turkish bath, due to a faulty heating
element. Or, if the initial temperature is lower than 25 °C and
the function is active for 5 minutes, the probe does not measure
a temperature increase of at least 5 °C (e.g. the shower unit door
is open).
TOP model only: the display shows AL7 for a few seconds and
the function ends normally.
AL7
u
(AL13) Activation of the safety thermostat.
This may occur during the Turkish bath.
TOP model: the display will show AL13 for a few seconds and
it will not be possible to start the function; if instead the alarm
appears when the function is in progress, it will be interrupted .
AL13
TT model: the "alarm" key remains on (white light) and the
"Turkish bath" key will flash; it will not be possible to start the
function. If instead the alarm appears when the function is in
progress, it will be interrupted.
u
(AL14) Error accessing the card where the audio files are
stored.
This may occur when playing, copying or deleting an audio
file.
TOP model only: the display will show AL14 for a few seconds
and it will not be possible to use the MP3 player .
If instead the alarm appears when the function is in progress, it
will be interrupted.
AL14
u (AL15) Radio malfunction.
This may occur due to failed communication between the
control panel and the system.
TOP model only: the display will show AL15 for a few seconds
and it will not be possible to use the radio.
If instead the alarm appears when the function is in progress, it
will be interrupted.
AL15
73