Accessories; Heater; Heater Installation; Camera Power Supply - Videotec HOV Bedienungsanleitung

7 Accessories

For further details on configuration and
use, refer to the relative manual.

7.1 Heater

7.1.1 Heater installation

Open the housing as described previously (6.1.1 How
to open the housing, page 6).
Fix the heater kit to the prearranged points on the
body of the housing.
The pre-wired heating element (01) should be
positioned between the 2 dissipators (02) before
attachment to ensure contact and hence guarantee
correct heat transmission.
Pass the heating wiring under the fixing slide of the
camera.
01
Fig. 8
Plug the multipolar female connector into the
corresponding male connector (J3, 6.1.3 Board
description, page 7).
Reposition the internal slide.
Close the housing.
MNVCHOV32_1351_EN

7.2 Camera power supply

7.2.1 Camera power supply installation

There are 2 types of camera power supply depending
on requirements.
Fig. 9
02
02
Fig. 10
Not usable in housings with wiper device
installed.
Pay attention to the voltage value used
when the circuit is powered. Depending on
requirements use the correct power supply
kit.
V from 100Vac to 240Vac, V
IN
V 230Vac, V 24Vac.
IN OUT
12Vdc.
OUT
9