Herunterladen Inhalt Inhalt Diese Seite drucken

Ipod/Iphone/Ipad Playback - Clas Ohlson iDeco Stereo 100BT Bedienungsanleitung

Ipod/ipad/iphone-lautsprecher mit bluetooth
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Operating instructions
Switching the speaker dock on
1. Set [ON/OFF] on the speaker's back panel to ON.
2. The display will read ("-") which indicates standby mode.
3. Press [Standby] on the remote or the speaker's control panel.
4. The display will show the selected input source. In the example "BT"
(Bluetooth) is used.
5. Press [Standby] again to return to standby mode.

iPod/iPhone/iPad playback

While docked
Note: Be extremely careful when connecting your iPod/iPhone/iPad to the dock,
otherwise there is a risk for damaging the dock.
1. Carefully insert your iPod/iPhone/iPad into the dock.
2. Reduce the volume on your iPod/iPhone/iPad to an acceptable low level.
3. Turn on the speaker system and press [INPUT] on the control panel or the remote
until "IP" (iPod mode) is shown in the display.
4. Adjust the volume to a desired level.
5. Control playback as described in the Buttons and functions section above.
Note: The buttons on the remote work differently depending on the model of iPod,
iPhone or iPad you are using.
Via Bluetooth
1. Turn on the speaker system and press [INPUT] on the control panel or the remote
until "BT" (Bluetooth mode) is shown in the display. After a few seconds the dot
next to the BT symbol will start flashing rapidly. This indicates that the speaker
system is scanning for other Bluetooth devices.
2. Activate Bluetooth on the device to be paired and place it in connecting mode.
Once the speaker has connected with the device the dot will then begin
flashing slowly. Note: If asked to enter a PIN code, you should enter "0000" (four
noughts). Certain devices may even require you to approve the connection.
3. Control playback as described in the Buttons and functions section above.
Note: The buttons on the remote work differently depending on the model of iPod,
iPhone or iPad you are using.
Note: Once the speaker has paired with the device, all subsequent connections will
occur automatically if the device is within range.
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis