Herunterladen Inhalt Inhalt Diese Seite drucken

Unpacking - OMCN Roll F4 Monitor Betriebsanleitung

Wuchtmaschinen
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
en
32 | ROLL F4 M | Commissioning
4.
Commissioning
4.1

Unpacking

1. Remove the steel band and fasteners.
2. Carefully lift off the packaging.
3. Remove the wheel guard, accessories and packaging
material from the packaging unit.
i
Check that the ROLL F4 M and the accessories are
in proper working order and that there are no visible
signs of component damage. In case of doubt, do
not start up the unit and consult customer service.
i
Remove the accessories and packaging material
from the packaging unit.
4.2
Setting up
1. Unscrew the screws that secure the ROLL F4 M to
the pallet.
WARNING – Defective or incorrectly
attached lifting straps!
Risk of injury due to ROLL F4 M falling down.
Check lifting straps for physical damage
before attaching.
Tighten lifting straps uniformly.
Lift ROLL F4 M carefully.
2. Attach slings of the same length and sufficient load
bearing capacity (min. 100 kg) as shown in the drawing.
|
1 695 600 693
2016-09-27
3. Hoist the ROLL F4 M with a crane. Erect in the
intended area, taking care to comply with the
specified minimum distances.
i
To ensure reliable, ergonomic use of the ROLL F4 M,
we advise setting it up at a distance of 500 mm from
the nearest wall.
4. Secure the ROLL F4 M to at least 3 points on the
floor.
OMCN spa

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis