Wheel Balancing - OMCN Roll F4 Monitor Betriebsanleitung

en 40 | ROLL F4 M | Wheel balancing
9.

Wheel balancing

WARNING – Incorrectly balanced wheels
Risk of injury due to change in handling
characteristics of vehicle.
€
ROLL F4 M must be positioned on a flat
surface and must be firmly bolted to the
floor.
€
Specified flange must be mounted on
clean and grease-free shaft.
€
Use the specified accessories (cone,
spacer rings).
€
Rim must contact flange accurately,
remove any dirt.
€
Perform a check measurement after
applying balancing weights.
1. Switch on the ROLL F4 M at the on/off switch.
« The "Start page" is opened.
2. Open the "wheel balancing main page" with < I >.
|
1 695 600 693 2016-09-27
9.1 Selection of vehicle type and
balancing program
i
Static balancing is recommended for wheels with
a width of less than 3.5": In this case only the rim
diameter value is entered. The values for distance
and width of the rim can be set arbitrarily in inches
or mm.
1. Check the currently selected type of vehicle
(passenger car or motorcycle) in the status bar, alter
if necessary and confirm with < I >.
2. Check the currently selected balancing program in the
status bar, alter if necessary and confirm with < I >.
Static balancing on plane 3
Static balancing on plane 2
Static balancing on plane 1
Pax2: Pax rim for concealed adhesive weights
Pax1: Pax rim with adhesive weights
Alu5: Adhesive weights on inside /
clip-on weights on outside
Alu4: Clip-on weights on inside /
adhesive weights on outside*
Alu3: Clip-on weights on inside /
concealed adhesive weights on outside
Alu2: Concealed adhesive weights
Alu1: Standard program for adhesive weights*
Standard program for clip-on weights
* The weight must be raised slightly if the adhesive weight can-
not be attached in the vicinity of the outer edge of the rim (rim
flange) on account of the design of the rim.
xxx
OMCN spa