Program Structure - OMCN Roll F4 Monitor Betriebsanleitung

en 38 | ROLL F4 M | Program structure
8.

Program structure

8.1 Wheel balancing
Selection of user 1, 2 or 3. The last settings and rim data
selected are assigned to the current user and stored.
Selection of type of vehicle (passenger car or
motorcycle); the type of vehicle selected is displayed in
the status bar.
Call-up of the "Enter rim data" menu.
Selection of balancing program; 11 passenger car
programs, 5 motorcycle programs; the program selected
is displayed in the status bar.
Starts measurement.
Ends measurement.
Display of the exact, non-rounded unbalance measured
value.
Selection of number of spokes.
The weight can be distributed behind the spokes after
measuring the unbalance.
Call-up of the "Unbalance minimization" program
(refer to Section 10).
Press < I > to return to the previous page.
|
1 695 600 693 2016-09-27
8.2 Rim data
Rim diameter input by way of o / u keys
Rim width input by way of o / u keys
Input of distance between ROLL F4 M and rim by way
of o / u keys
Press < I > to return to the previous page.
Selection of balancing program; 11 passenger car
programs, 5 motorcycle programs; the program selected
is displayed in the status bar.
Switching of units (mm / inch)
Selection of user 1, 2 or 3. The last settings and rim data
selected are assigned to the current user and stored.
OMCN spa