User Information; Product Description - OMCN Roll F4 Monitor Betriebsanleitung

en 30 | ROLL F4 M | User information
2.

User information

2.1 Important notes
Important information on copyright, liability and
warranty provisions, as well as on equipment users
and company obligations, can be found in the separate
manual "Important notes on and safety instructions for
OMCN spa Tire Service Equipment". These instructions must
be carefully studied prior to start-up, connection and
operation of the ROLL F4 M and must always be heeded.
2.2 Safety instructions
All the pertinent safety instructions can be found in
the separate manual "Important notes on and safety
instructions for OMCN spa Tire Service Equipment". These
instructions must be carefully studied prior to start-up,
connection and operation of the ROLL F4 M and must
always be heeded.
2.3 Electromagnetic compatibility (EMC)
The ROLL F4 M satisfies the requirements of the EMC
directive 2014/30/EU.
The ROLL F4 M is a class B product as per EN 61 326.
|
1 695 600 693 2016-09-27
3.

Product description

3.1 Intended use
The ROLL F4 M is a wheel balancing machine featuring
mechanical wheel clamping for the balancing of car,
light van and motorcycle wheels with a rim diameter of
12" – 22" and a rim width of 1" –
The ROLL F4 M is to be used exclusively for this
purpose and solely for the range of applications
specified in these instructions. Any other purpose is not
consistent with the intended use and is therefore not
permissible.
!
The manufacturer cannot accept any liability for
possible damage arising from improper use.
3.2 Prerequisites
The ROLL F4 M must be installed on a flat surface
made of concrete or similar material and anchored in
position.
i
An uneven or vibrating surface can lead to
inaccurate unbalance measurements.
3.3 Scope of delivery
Designation
ROLL F4 M
Quick-action clamping nut
Centering flange
Centering cones (3x) and adapters
Manual vernier caliper
Weight pliers
Measuring compasses
Calibrating weight
3.4 Special accessories
Designation
Wheel lift
Set of quick-action clamping cones M10x1.25 1 695 612 100
Third centering cone dia. 89 to 132 mm
Fourth centering cone dia. 120 to 174 mm
Spacer ring for rims (large rim offset)
Three-arm flange for light commercial
vehicles
Clamping kit for swinging arms (dia. 19 mm) 1 695 654 060
Infinitely variable universal flange for cars
(3-4-5 hole)
Motorcycle flange
Shaft kit, dia. 10 mm
Calibration weight (calibrated)
Gauge arm
13".
Order number
Refer to rating
plate
1 695 616 200
1 695 602 400
–
1 695 629 400
1 695 606 500
1 695 602 700
1 695 654 377
Order number
1 695 900 004
1 695 653 449
1 695 606 300
1 695 606 200
1 695 653 420
1 695 654 043
1 695 654 039
1 695 653 430
1 695 654 376
1 695 655 678
OMCN spa