Attaching Balance Weights; Splitting Balance Weights - OMCN Roll F4 Monitor Betriebsanleitung

en 42 | ROLL F4 M | Wheel balancing
9.4

Attaching balance weights

i
If the unbalance measured at the wheel is extremely
high (e. g. static unbalance >50 g) it is advisable
to perform "Unbalance minimization"
(refer to Section 10).
9.4.1

Splitting balance weights

i
The "split program" is called up after measurement
if the balance weights have to be attached at a
certain position (e.g. behind the spoke or spokes).
We recommend attachment using Easyfix®.
1. Select the split program and the number of spokes.
2. Move the required position (e.g. a spoke) to the
12 o'clock position.
3. Confirm with <OK>.
"
The split weights and positions are indicated.
9.4.2 Without Easyfix®
1. Turn the wheel by hand.
« As soon as the correct position for attachment
of a balance weight has been reached, a green
square appears on the monitor.
i
Blue squares on either side of the tyre on the
monitor indicate the direction in which the wheel
has to be turned to move it to the correct position
for the next balance weight.
2. Select a balance weight of the required value
(next to the green square).
3. Attach the balance weight at the highest vertical
position (12 o'clock) of the wheel.
i
The position depends on the setting selected for the
attachment location (refer to Section 8.3.2)
4. Repeat the procedure for the 2nd balance weight.
i
After attaching the balance weights, the unbalance
must be measured again for an exact check of the
balance.
|
1 695 600 693 2016-09-27
9.4.3 With Easyfix®
i
Only the 3 programs Alu2, Alu3 and Pax2 support the
attachment of the adhesive weights with Easyfix®.
1. Turn the wheel by hand.
« As soon as the correct position for attachment
of a balance weight has been reached, the wheel
is locked in position and a green square appears
on the monitor.
i
Blue squares on either side of the tyre on the
monitor indicate the direction in which the wheel
has to be turned to move it to the correct position
for the next balance weight.
2. Select an adhesive weight of the required value (next
to the green square).
3. Insert the adhesive weight in the electronic vernier
caliper.
4. Move the electronic vernier caliper into the rim.
« The attachment location of the adhesive weight
is indicated.
« The electronic vernier caliper is locked at this po-
sition (the colour of the square changes from yel-
low to green).
5. Attach the adhesive weights with the aid of the
electronic vernier caliper.
6. Repeat the procedure for the 2nd balance weight.
i
After attaching the balance weights, the unbalance
must be measured again for an exact check of the
balance.
OMCN spa