Fitting The Wheel Guard - OMCN Roll F4 Monitor Betriebsanleitung

4.3

Fitting the wheel guard

i
The back of the ROLL F4 M contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the ROLL F4 M. To do
so, screw the 4 supplied Allen screws and 4 washers
into the blind rivet nuts and tighten (width A/F 6).
Fig. 2: Fastening the supporting arm to the ROLL F4 M.
1 Supporting arm
2 Allen screw
3 Washer
2. Screw the wheel guard loosely to the supporting
journal with 2 screws and 2 washers (width A/F 6).
i
Make sure that the open wheel guard is lying on the
supporting arm (rubber buffer).
4
3
2
Fig. 3: Securing the wheel guard
1 Screw
2 Washer
3 Supporting arm
4 Wheel guard
3. Firmly tighten the screws.
OMCN spa
1
2
3
1
Commissioning | ROLL F4 M | 33
4.4 Fitting monitor
i
The back of the ROLL F4 M contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the ROLL F4 M. To do
so, screw the 4 supplied Allen screws and 4 washers
into the blind rivet nuts and tighten (width A/F 6).
3
2
Fig. 4: Fastening the supporting arm to the ROLL F4 M.
1 Supporting arm
2 Allen screw
3 Washer
2. Fix the monitor to the support arm, securing the
bracket with 4 screws and 4 washers.
Fig. 5: Fitting monitor
1 Allen screw
2 Washer
1
|
1 695 600 693 2016-09-27
en