Connecting The Ac Adapter For Use With The Pan/Tilt Head - Panasonic AW-PH360L Bedienungsanleitung

Connections

$ Connecting the AC adapter for use with the pan/tilt head

Connect the pan/tilt head with the AW-PS300A AC adapter designed for use with the
pan/tilt head.
> DC 12V IN terminal board
Connect this to the DC 15V OUT
connector on the AC adapter
(AW-PS300A). (The voltage output from
the AC adapter is set to 15V: this takes
into consideration the voltage drops due
to the possible extension of the DC
cable between the pan/tilt head and AC
adapter.)
Make sure that the positive + and
negative - ends of the wires are
connected to the same signs on the
connector.
Use a cable with a nominal cross
section of 1.25 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
? LAMP CONTROL terminal board
Connect this only when the power of a
halogen lamp is to be supplied from the
AC adapter (AW-PS300A).
This connector is connected to LAMP
CONTROL on the AC adapter for the
pan/tilt head.
The symbols C and S on the wires must
2
or more that meets
- 25 (E) -
Standard bare end length 11 mm
It is recommended that the tip be soldered.
match the same symbols on the
connector.
Use a cable with a nominal cross
section of 0.3 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
@ OP terminal board
Connect this only when the OP SW
CONTROL OUT connector on the AC
adapter (AW-PS300A) is to be used.
Connect it to the OPTION SW
CONTROL IN connector on the AC
adapter (AW-PS300A).
Use a cable with a nominal cross
section of 0.3 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
AC adapter for use with the
pan/tilt head: AW-PS300A
2
or more that meets
2
or more that meets