Panasonic AW-PH360L Bedienungsanleitung Seite 41

Connections
?When the unit is to be connected by a network, and the camera and pan/tilt head are to
be controlled by a personal computer
Nominal cross section
2
1.25 mm
AC adapter:
AW-PS300A
• Use the pan/tilt head cable (AW-CA50F29) to connect the unit with the convertible
camera containing the plugged-in WEB card.
• Set controller selection switch SW1 to the right side (RP501), and select the
transmission signal selection setting that supports the WEB card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit connector with
the personal computer (Windows) via the hub.
• Install the browser software (Internet Explorer or Netscape) in the personal computer
(Windows).
• Using the browser software, input the IP address which has been set in the WEB card,
and check that the pan/tilt head and camera can be controlled by the personal
computer.
For further details, refer to the web card instructions.
Pan/tilt head cable
(AW-CA50F29)
10BASE-T (equivalent to UTP category 5)
straight cable (max. 100 m)
or more
10BASE-T (equivalent to
UTP category 5) straight
cable (max. 100 m)
Hub
- 40 (E) -
Personal computer
(Windows)