Panasonic AW-PH360L Bedienungsanleitung Seite 35

Connections
9When the pan/tilt head is to be controlled by the AW-RP400 pan/tilt head control panel
for transmitting composite or component signals (and the AW-CB400 remote operation
panel is used to control the camera)
10BASE-T (equivalent to
UTP category 5) straight
cable (max. 500 m)
Nominal cross section
2
1.25 mm or more
AC adapter:
AW-PS300A
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the transmission signal
selection setting that supports the analogue/IEEE1394 card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit's CONTROL IN IP/RP
connector with the controller's CONTROL OUT TO PAN/TILT HEAD connector.
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's VIDEO OUT connector with
the cable compensation unit's Y VIDEO IN connector (when composite signals are to be transmitted).
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's Y OUT connector,
Pr/SDI OUT connector and Pb OUT connector with the cable compensation unit's Y VIDEO IN
connector, PR C IN connector and PB IN connector (when component signals are to be transmitted).
• Use a coaxial cable to connect the cable compensation unit's Y VIDEO IN connector, PR C IN connector
and PB IN connector with the colour monitor's VIDEO input connector or component input connectors.
• Use the cable supplied with the remote operation panel to connect the controller's CAMERA
CONTROL IN FROM ROP connector with the remote operation panel's CONTROL OUT TO
CONTROL PANEL connector.
• Check that the pan/tilt head and camera can be controlled by the controller.
Camera cable
(supplied)
Cable compensation unit:
AW-RC400
Coaxial cable (BBC No.PSF1/2M,
BELDEN 8281, max. 500 m)
- 34 (E) -
Genlock signals must be supplied if
a multiple number of cameras and
pan/tilt heads are to be used.
Remote operation
panel:
AW-CB400
Pan/tilt control panel:
AW-RP400
Colour monitor
Cable supplied
with AW-CB400
Coaxial cable