Panasonic AW-PH360L Bedienungsanleitung Seite 31

Connections
5When the camera and pan/tilt head are to be controlled by the AW-RP505 control panel
for transmitting component signals
Nominal cross section
2
1.25 mm
AC adapter:
AW-PS300A
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the transmission
signal selection setting that supports the analogue/IEEE1394 card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit's CONTROL IN IP/RP
connector with the multiport hub's PAN/TILT CONTROL OUT connector.
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's CAMERA
CONTROL IN connector with the multiport hub's CAMERA CONTROL OUT connector.
• Use a 10BASE-T straight cable (UTP category 5) to connect the multiport hub's PAN/TILT
CONTROL IN connector with the controller's PAN/TILT CONTROL OUT connector.
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the multiport hub's
CAMERA CONTROL IN connector with the controller's CAMERA CONTROL OUT connector.
• Use coaxial cables to connect the unit's Y OUT connector, Pr/SDI OUT connector and Pb
OUT connector with the component input connectors on the colour monitor.
• Check that the pan/tilt head and camera can be controlled by the controller.
• Transmitting component signals over a long distance requires a separate cable
compensation unit.
Camera cable
(supplied)
10BASE-T
(equivalent to UTP
category 5) straight
cable (max. 10 m)
or more
Coaxial cable (BBC No.PSF1/2M,
BELDEN 8281, max. 500 m)
Genlock signals must be supplied if
a multiple number of cameras and
pan/tilt heads are to be used.
Coaxial cable
10BASE-T
(equivalent
to UTP
category 5)
straight
cable (max.
500 m)
- 30 (E) -
Colour monitor
Multi hybrid control panel:
AW-RP505
Coaxial
cable (BBC
No.PSF1/2M,
BELDEN
8281, max.
10 m)
Multiport hub:
AW-HB505