Safety Instructions; Controller; Thermostat/System Device - Uponor Smatrix Base PRO Kurzanleitung

Safety instructions

This quick start guide to serves as a reminder for
experienced installers. We strongly recommend reading
the full manual before installing the control system.

Controller

W !
ARNING
The Uponor system uses 50 Hz, 230 V AC
power. In case of emergency, immediately
disconnect the power.
W !
ARNING
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualifi ed
electrician.
W !
ARNING
The transformer module is heavy and might
detach if the controller is held upside down
without the cover on.
C !
AUTION
To avoid interference, keep installation/data
cables away from power cables of more than
50 V.
C !
AUTION
Ensure that each actuator is connected to the
correct channel so that the thermostats are
controlling the correct loops.
N O T E !
Wires between transformer and controller card
needs to be disconnected prior to detaching.
N O T E !
Connect only one actuator for each channel.
Channels 01 and 02 have double outputs (a
and b) for two actuators.
U P O N O R S M AT R I X B A S E P R O · Q U I C K G U I D E
QUICK GUIDE

Thermostat/System device

N O T E !
Registration of at least one thermostat must
be done before registering a system device.
N O T E !
Up to 16 controllers can be registered to an
interface.
C !
AUTION
If more than one controller is available in the
system, register the thermostat as a system
device to the master controller.
C !
AUTION
The switches in public the thermostat must
be set before the thermostat is registered.
C !
AUTION
The switches, in the public thermostat, must
be set to one of the available functions,
otherwise it cannot be registered.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SI
SK
5