Maintenance And Cleaning; Switching On And Off - LIVARNOLUX IAN 282505 Bedienungs- Und Sicherheitshinweise

Safe working
Install the light so that it is protected from mois-
ture, dirt and excessive heat temperature.
Constant attentiveness is required! Always pay
attention to what you are doing and act with
common sense. Never use the light if you are
having difficulty concentrating or do not feel
well.
Familiarise yourself before use with all instructions
and diagrams in this manual as well as with
the light itself.
This product is only to be used as a wall light
or reading light. Do not use this light as a night
light.
Start-up
Installing / uninstalling the light
Connect the plug of the light to the mains socket.
Check that it is correctly plugged in. Your light
is now ready to use.
Directing the spotlight
Only change the direction of the spotlight
with the light unplugged.
Allow the light to cool completely.
Turn the spotlight
1
direction.

Switching on and off

Switching the light on:
Set the switch to the „AUTO" position.
2
– Motion detector is active.
– The automatic darkness sensor is switched on.
– The light switches on automatically for ap-
prox. 60 seconds, if there is motion within
the detection range.
– The function only operates if there is darkness.
Safety / Start-up / Maintenance and Cleaning / Disposal
1
carefully in the desired
Set the switch to the „ON" position.
2
– The light is switched on permanently.
– The motion detector is switched off.
– The automatic darkness sensor is switched off.
Switching the light off:
Set the switch to the „OFF" position.
2
– The light is switched off permanently.
Note: The range of the motion detector is max.
3.0 m.

Maintenance and Cleaning

RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains power before
cleaning.
RISK OF ELECTRIC SHOCK!
For reasons of electrical safety, never clean the
light with water or other fluids, or immerse it in
water. Only use a dry, lint-free cloth for cleaning.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the light to cool com-
pletely.
Do not use solvents, benzene or similar
substances. They could damage the light.
Only use a dry, lint-free cloth for cleaning.
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities. The Green
Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
GB 7