Parts Description; Technical Data; Safety Notes - LIVARNOLUX IAN 282505 Bedienungs- Und Sicherheitshinweise

Introduction / Safety

Parts description

Spotlight
1
Switch (continuous operation, or motion
2
detector in the case of darkness, or „off")

Technical Data

Item no.: 14100204L / 14100206L /
14112008L
Operating voltage: 230–240 V∼, 50 Hz
Lamp: 7 SMD LEDs (SMD =
surface mounted device)
per spotlight (the LEDs are not
replaceable)
Rated power: 1 x 3.5 W
Power factor: 0.47
Rated power input: 32 mA
Protection class: I
Protection type: IP20
Safety

Safety notes

Damage due to failure to comply with these
operating instructions will invalidate the guarantee!
We assume no liability for consequential damage!
We assume no liability for material damage or
personal injury due to improper handling or failure
to comply with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
A damaged light means danger
of death from electric shock!
Check the light regularly and before every use
to see if there is any damage to the casing and
mains plug.
6 GB
The light can not be repaired. If the light is
damaged, the product must be disposed of.
Ensure before use that the available mains
voltage is the same as the voltage required for
operating the lamp (see „Technical Data").
Strictly ensure that the light does not come into
contact with water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a damp or conducting
surface.
Do not use the light with sockets which have a
hinged cover.
Prevent fire and
injury hazards
RISK OF INJURY! Check the light regularly
and before every use to see if there is any
damage to the casing and mains plug.
Never use the light if any defects have been
identified.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! To prevent burns, ensure
that the light is switched off and has cooled
down before touching it. Lamps develop a lot
of heat in the area of the lamp head.
Allow the light to cool completely.
Do not look directly into the light source (lamp,
LED, etc.).
The lamp is not replaceable.
If the illuminant has reached the end of its life,
the entire light must be replaced.
This light is not suitable for dimmer
or electronic switches.
In order to disconnect the light completely from
the power supply, the light must be removed
from the socket.
Do not leave the light or packaging material
lying unattended. Plastic film or bags and
Styrofoam etc. can turn into dangerous toys for
children.