Setting The Daylight Level; Orientating The Motion Detector; Cleaning And Storage; Troubleshooting - LIVARNOLUX HG04857A Montage-, Bedienungs- Und Sicherheitshinweise

Setting the daylight level

Turn the rotary control LUX
of the motion detector
increase the daylight level. In position , the
motion detector only responds at pitch-
9
black night (approx. 5 lx). In position ,
the motion detector
9
daylight levels, as long as about 20,000 lx
are not exceeded (see Fig. C).
Orientating the
motion detector
Loosen the fastening screws
motion detector .
9
Turn the rotary control LUX
. Orient the motion detector
central region of the desired coverage area.
Move about through the coverage area un-
til you are satisfied with the response char-
acteristics of the motion detector
the proper orientation, change the position
of the rotary control SENS
tation of the motion detector
Re-tighten the fastening screws
adjustment.
Turn the rotary control LUX
position. These can be determined during
the dawn or twilight hours during which the
spotlight should respond. Slowly turn
10
the rotary control LUX
reacts to movement within the coverage area.
on the bottom
17
clockwise to
9
also responds at
of the
7
to position
17
into the
9
. To find
9
or the orien-
18
.
9
to fix the
7
to the desired
17
clockwise until it
17

Cleaning and storage

Press the ON / OFF switch
position if you will not be using the product
and want to store it.
Check the motion detector
cell for dirt regularly. If dirt or is present,
12
remove it to guarantee flawless function of
the product.
During the winter, keep the product and
especially the solar cell
and ice.
Clean the product with a lint-free, slightly
moist cloth and mild cleaning agent.

Troubleshooting

= Fault
= Cause
= Solution
= The product does not switch on.
= The ON / OFF switch
OFF position.
= Press the ON / OFF switch
position and red LED indicator of ON / OFF
switch lights on at the same time.
11
= The rotary rotary control LUX
too dark.
= Adjust the rotary control LUX
brighter.
= The motion detector
rectly oriented.
= Clean the motion detector
= The sensitivity of the motion detector
too low.
= Readjust the sensitivity of the motion detec-
tor (see section "Adjusting the sensitivity
9
of the sensor").
into the OFF
11
and the solar
9
free from snow
12
is in the
11
into the ON
11
is adjusted
17
so it is
17
is dirty or is incor-
9
or reorient it.
9
is
9
GB 11