Kostenloses Bestell-Fax: 08 00. 7 86; Toll-Free Order Fax: 08 00. 7 86; Kite Marks/Waste Water Regulations; Commissioning - Storch 85 Bedienungsanleitung

is extracted directly into the suction unit through the
suction hose without any notable volume of water
escaping from the cleaning attachment.
This makes it possible to use the high pressure cle-
aner for interior work (e.g. stairwells / churches) wi-
thout any additional preparation. The suction unit
can be used with one or two motors depending on
the required extraction performance. To allow this to
happen, the motors are switched separately at the
main switch. The waste water is filtered in the suc-
tion unit using a filter (210 - 400 mµ available) and
then continually discharged via the discharge hose by
the integrated immersion pump.
CAuTION:
The discharge hose diameter must
not be below ¾".
The machine is supplied with a 400 my reusable
filter.

Kite marks/Waste water regulations:

IP 44
CAuTION:
Before discharging waste water into
waste water channels, you must ob-
tain a permit from the local water
authority.
Use only biodegradable strippers that
comply with water hazard class I, if you intend to di-
scharge the waste water into a waste water channel,
as dissolved strippers cannot be filtered. In all other
cases, you may need to collect the waste water in
tanks and dispose of the waste water in line with
your local water authority's regulations.
CAuTION:
You cannot use the "Radikalfresser"
stripper by Sikkens with this machi-
ne.
Commissioning the STORCH High Pressure Water
Recovery System:
The high pressure cleaner and suction unit must be
connected to separate power supplies as the suction
unit requires a current of approx. 11 A, and - depen-
ding on the pressure cleaner you use - a single 16 A
power supply could be overloaded. Place the upper
suction basket and the upper container ring on the
lower barrel and always connect the two using the
3 tension locks! Using the high pressure hose, con-
nect the high pressure cleaner to the cleaning attach-
ment. Using the suction hose connect the cleaning
attachment and the suction unit. Plug the immersion
pump plug (on the outside of the barrel) into the so-
cket provided on the suction basket.
Check whether the suction unit, pump and discharge
hose are ready for operations. To do so, switch on
the suction unit and the high pressure cleaner (switch
the two motors on the High Pressure Water Recovery
System on one after another - not at the same time,
and then switch on the high pressure cleaner) and
place the cleaning attachment on the surface you
wish to clean. Actuate the pistol grip on the cleaning
attachment and check whether the rotating nozzle is
turning.
Water pressure and temperature
The cleaning attachment is designed for a max. pres-
sure of 200 bar. Set an appropriate pressure at the
high pressure cleaner to avoid damaging the surface
to be cleaned. For soft surfaces (e.g. interior plaster
work) use the wide plastic rollers (as supplied) and the
flat jet rotation nozzle (accessory).
You can use a Hot Box (Art.-No. 65 03 00) to impro-
ve working speeds by up to 40%, and considerably
improve the cleaning performance, due to the use of
hot water.
CAuTION:
The max. preset water temperature
must not exceed 85°C.
A temperature feeler switches off the
suction unit and the integrated immer-
sion pumpin case of excessive temperature. Allow
the system to cool down for approx. 15 minutes and
then switch the suction unit and immersion pump
back on. For more effective cooling, please open the
suction unit by removing the suction basket from the
lower barrel.
Cleaning attachment:
43