Safety Precautions - Acson CB Serie Installationsanleitung

! WARNING
• Installation and maintenance shall be performed by
qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the
national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to
that of the name plate before commencing wiring work
according to the wiring diagram.
• The unit must be GROUNDED to prevent possible
hazard due to insulation failure.
• All electrical wiring must not touch the water piping,
compressor or any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before
installing or servicing the unit.
• IMPORTANT: DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
• Disconnect from the main power supply before servicing
the air conditioner unit.
• DO NOT pull the power cord when the power is ON.
This may cause serious electrical shocks which may
result in fire hazards.
• Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1m from TVs and radios, to
prevent distorted pictures and static. {Depending on the
type and source of the electrical waves, static may be
heard even when more than 1 m away}.
Disposal requirements
Your air conditioning product is marked with this symbol. This means that electrical and electronic products
shall not be mixed with unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the
refrigerant, of oil and of other parts must be done by a qualified installer in accordance with relevant local and
national legislation.
Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By
ensuring this product is disposed of correctly, you will help to prevent potential negative consequences for the
environment and human health. Please contact the installer or local authority for more information.
Batteries must be removed from the remote controller and disposed of separately in accordance with relevant
local and national legislation.

SAFETY PRECAUTIONS

Please take note of the following important points when
installing.
• Ensure that the drainage piping is connected
properly.
• Ensure that the unit's panel is closed after service or
installation.
• Air swing connector and LED wire connector shall
be inside the control box.
• Sharp edges and coil surfaces are potential locations
which may cause injury hazards. Avoid from being
in contact with these places.
• Before turning off the power supply set the remote
controller's ON/OFF switch to the "OFF" position
to prevent the nuisance tripping of the unit. If this is
not done, the unit's fans will start turning automatically
when power resumes, posing a hazard to service
personnel or the user.
• Do not operate any heating apparatus too close to
the air conditioner unit. This may cause the plastic
panel to melt or deform as a result of the excessive heat.
• Ensure the color of wires of the outdoor unit and the
terminal markings are same to the indoors
respectively.
NOTICE
1-2
! CAUTION
If the drainage piping is not connected properly, it
may cause water leakage which will dampen the
furniture.
Unsecured panels will cause the unit to operate
noisily.