Stryker L9000 LED Bedienungsanleitung Seite 7

SURGICAL DRAPES OR OTHER FLAMMABLE MATERIAL
SO MAY RESULT IN FIRE
STANDBY MODE WHENEVER THE SCOPE IS REMOVED FROM THE
LIGHT CABLE OR THE DEVICE IS UNATTENDED
SCOPE LIGHT POST
WILL TAKE SEVERAL MINUTES TO COOL OFF AFTER BEING PLACED
IN STANDBY MODE
OR BURNS TO THE PATIENT
W T
ARNING O HELP AVOID POTENTIAL SERIOUS INJURY TO THE USER AND
THE PATIENT AND
1. Read this operating manual thoroughly, especially the warnings, and
be familiar with its contents prior to using this equipment.
2. Carefully unpack the unit and check if any damage occurred during
shipment. If damage is detected, please refer to the "Warranty" section
in this manual.
3. Be a qualified physician, having complete knowledge of the use of this
equipment.
4. Test this equipment prior to a surgical procedure. This unit was fully
tested at the factory before shipment.
5. Attempt no internal repairs or adjustments that are not specifically
detailed in the Troubleshooting, Cleaning and Maintenance sections of
this operating manual.
6. No modification of this equipment is allowed.
7. Never sterilize any part of the L9000 console.
8. Disconnect the L9000 from the electrical outlet when inspecting the
fuses.
9. To avoid risk of electric shock, this equipment must only be connected
to a supply mains with protective earth ground.
10. Do not position the console so that it is difficult to disconnect the
power cord from the supply mains.
11. Never use this equipment in the presence of flammable or explosive
gases.
. A
LWAYS PLACE THE LIGHT SOURCE IN
,
LIGHT CABLE ADAPTER
,
AND THEREFORE MAY STILL RESULT IN FIRE
, ,
USER OR INANIMATE OBJECTS
/
OR DAMAGE TO THIS DEVICE
,
AS DOING
. T
HE SCOPE TIP
,
AND LIGHT CABLE TIP
.
,
THE USER MUST
,
:
3