System Operation; Powering The System On And Off - Stryker L9000 LED Bedienungsanleitung

W I
ARNING F THE LIGHT SOURCE IS NOT IN
REMOVING THE CABLE
DIRECTLY OUT OF THE LIGHT SOURCE BRIEFLY BEFORE TURNING
OFF
Note The Light Source will default to Standby mode when a light cable
is inserted.

System Operation

Note Before operating the L9000, see the "Setup and Assembly" section
of this manual.

Powering the System On and Off

To power on the L9000:
Press the power switch on the front panel. The LCD will indicate that the unit is
in Standby mode.
Note The light will not illuminate unless a light cable is installed in the
cable port.
To power off the L9000:
1. Put the light source unit into Standby mode.
2. Disconnect the light cable from the L9000 console.
3. Run the fan for at least one minute to cool the unit.
4. Press the power switch on the front panel of the L9000.
W T
ARNING
SIDE FAN VENTS
RESULT IN DAMAGE TO THE
12
,
POSSIBLY CAUSING INJURY TO THE USER
O ALLOW FOR ADEQUATE COOLING
. F
S
TANDBY MODE PRIOR TO
,
THE HIGH INTENSITY LIGHT WILL SHINE
AILURE TO FOLLOW THIS INSTRUCTION MAY
L9000
OR A POSSIBLE FIRE
' .
S EYES
,
NEVER BLOCK THE REAR OR
.