Checking The Esst Feature - Stryker L9000 LED Bedienungsanleitung

Checking the ESST Feature

The L9000 is equipped with Electronic Scope Sensing Technology (ESST),
a special safety feature that helps prevent accidental fires or burns to the patient or
user caused by a light cable not connected to a scope. This feature will only work
if the L9000 is used with an ESST light cable. When operated with an ESST light
cable, the L9000 senses when the scope and light cable are separated, and places
the light source in Standby mode. In Standby mode, the L9000 will reduce light
output to a minimum, preventing the light cable from generating excessive heat.
To verify the ESST feature is active, perform the following test before every
surgical procedure:
1. Set up the L9000 system with an ESST light cable and scope, and then
power on the system.
2. Place the L9000 in Activate mode.
3. Remove the light cable from the ESST scope adapter.
The L9000 should return to Standby mode, indicating that the ESST feature is
functioning properly.
W A
ARNING
STANDBY MODE
THE UNIT FAILS TO RETURN TO
FAULT WITH THE
ESST
W E
ARNING VEN WITH
STANDBY MODE
LIGHT CABLE ADAPTER DIRECTLY ON THE PATIENT
OTHER FLAMMABLE MATERIAL
T
LIGHT CABLE TIP WILL TAKE SEVERAL MINUTES TO COOL OFF
AFTER BEING PLACED IN STANDBY MODE
STILL RESULT IN FIRE AND
AN INANIMATE OBJECT IF NOT USED PROPERLY
THE SCOPE OR THE LIGHT CABLE ON THE PATIENT
DRAPES
DEVICE IS IN STANDBY MODE
18
LWAYS CHECK TO ENSURE THAT THE UNIT HAS SWITCHED INTO
,
BEFORE ASSUMING ESST SAFETY PROTECTION
ESST
SAFETY PROTECTION
ESST
PROTECTION
,
NEVER PLACE THE TIP OF THE LIGHT CABLE OR
,
HE SCOPE TIP SCOPE LIGHT POST
,
OR OTHER FLAMMABLE MATERIAL
S
TANDBY MODE
. I
FEATURE N THIS CASE
,
AND RETURN THE UNIT FOR SERVICE
,
OR WHEN THE
,
AS BURNS OR FIRE MAY RESULT
,
LIGHT CABLE ADAPTER
,
/
OR BURNS TO THE PATIENT
.
,
THERE MAY BE A
,
DO NOT ASSUME
L9000
IS IN
,
DRAPES OR
,
AND THEREFORE MAY
,
USER
. D
O NOT PLACE
,
ON THE
,
EVEN WHEN THE
. I
F
.
.
AND
,
OR