Adjusting The Brightness - Stryker L9000 LED Bedienungsanleitung

Adjusting the Brightness

The L9000 has up and down buttons for adjusting brightness.
Press the up arrow to increase brightness, and press the down arrow to decrease
brightness. The selection will appear on the LCD as a percentage between 0
and 100.
When in Standby mode, the previous Activate mode brightness level appears in
the lower right-hand corner.
W T
ARNING
WILL BE GENERATED IN THE SCOPE AND THE TIP OF THE CABLE
A
THE MONITOR BEFORE ADJUSTING THE BRIGHTNESS LEVEL OF THE
LIGHT SOURCE
SOURCE TO THE MINIMUM BRIGHTNESS NECESSARY TO
ILLUMINATE THE SURGICAL SITE
INSTRUCTION COULD RESULT IN FIRE OR BURNS TO THE PATIENT
USER OR AN INANIMATE OBJECT
INTERNAL SHUTTER OF THE CAMERA HIGHER IN ORDER TO RUN
THE LIGHT SOURCE AT A LOWER INTENSITY
W T
ARNING
THE TIP OF THE SCOPE MAY EXCEED
OPERATED AT HIGH LEVELS OF BRIGHTNESS FOR EXTENDED
PERIODS OF TIME
BURNS TO THE PATIENT
14
HE HIGHER THE BRIGHTNESS
LWAYS ADJUST THE BRIGHTNESS LEVEL OF THE CAMERA AND
.
ADJUST THE BRIGHTNESS LEVEL OF THE LIGHT
HE SURFACE TEMPERATURE NEAR THE SCOPE ADAPTER AND AT
. T
,
THE MORE HEAT ENERGY THAT
.
FAILURE TO FOLLOW THIS
. I
N ADDITION
41ºC
HE HEATED SCOPE AND ADAPTER MAY CAUSE
,
USER OR AN INANIMATE OBJECT
,
ADJUST THE
.
IF THE UNIT IS
.
.
,