Replacing Lamps; Cleaning And Care; Disposal - LIVARNO LUX 3433-025L Montage-, Bedienungs- Und Sicherheitshinweise

Open the connection socket
the connection housing
Pull the protective tube
nection lead .
6
Connect the connection cable of the light to
the power cord
6
(Fig. B).
Also ensure that the colour connection of the
wires is correct when connecting (L or 2 = black
or brown, N or 1 = blue).
Connect the earth wire (3 = green-yellow) to the
marked earth terminal
Close the connection socket
the connection housing
Fasten the connection housing
which are included
Use a clean, lint-free cloth to insert the lamp.
Insert the bulb GU10, 5 W, into the socket
14
carefully and tighten it with a ¼ turn in a clock-
wise direction.
Screw the light body
ing again by tightening the screws
1
wise (Fig. D).
Check for correct fitting.
Your light is now ready for use (Fig. E).
Reinsert the fuse or switch the circuit breaker
back on.
Replacing lamps (3435-024L /
3436-025L)
Note: The light / LED module is not replaceable in
models 3433-025L and 3434-024L.
CAUTION! RISK OF ELECTRIC SHOCK!
To replace the lamp, first disconnect the light
from the mains circuit. To do so, remove the fuse
or switch off the circuit breaker in the fuse box
0 position.
Allow the light to cool down completely.
Use a dry, lint-free cloth when replacing a lamp.
3435-024L:
Unscrew the light body
housing by loosening the screws
1
ter-clockwise (Fig. A).
on the rear of
15
.
1
over the mains con-
8
using the terminal block
(Fig. B).
on the rear of
15
.
1
with the screws
1
(Fig. C).
5
to the connection hous-
2
clock-
3
from the connection
2
coun-
3
Installation / Cleaning and Care / Disposal
Twist the defective lamp
of the bulb socket.
Carefully insert a new lamp into the socket and
tighten clockwise.
Check for correct fitting.
Screw the light body
7
housing again by tightening the screws
1
clockwise (Fig. D).
3436-025L:
Unscrew the light body
housing by loosening the screws
1
ter-clockwise (Fig. A).
Twist the defective lamp
clockwise out of the bulb socket.
Insert a new lamp into the socket and tighten it
with a ¼-turn clockwise.
Check for correct fitting.
Screw the light body
housing again by tightening the screws
1
clockwise (Fig. D).
Reinsert the fuse or switch the circuit breaker
back on.

Cleaning and Care

CAUTION! RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains circuit before
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box 0 position.
Do not use solvents, petrol, etc. Otherwise the
light will be damaged.
Allow the light to cool down completely.
Only use a dry, lint-free cloth for cleaning.
Reinsert the fuse or switch the circuit breaker
back on.

Disposal

The package and packaging materials
consist entirely of environmentally friendly
materials. They can be disposed of at
your local recycling facility.
anti-clockwise out
14
to the connection
2
3
from the connection
2
coun-
3
with a ¼-turn anti-
14
to the connection
2
3
GB 9