Safety Notices; Preparation; Required Tools And Material - LIVARNO LUX 3433-025L Montage-, Bedienungs- Und Sicherheitshinweise

Safety notices

DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS
AND SMALL CHILDREN! Never
leave children unattended with the packaging
material. The packaging material represents a
danger of suffocation. Children frequently un-
derestimate the dangers. Please keep children
away from the product at all times.
Danger to life from
electric shock!
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
We assume no liability for material damage or
personal injury due to improper handling or
failure to comply with the safety instructions!
Never use the light if any defects have been
identified. Prior to installation, remove the fuse
or switch off the circuit breaker 0 position in the
fuse box.
Prior to installation, verify that the mains voltage
to be used corresponds with the operating volt-
age required for the light (230 V∼).
Be careful not to damage lines during installation.
Risk of burns and injury!
Do not install the light if the lamp shade is
defective. Should this be the case, contact the
service centre for a replacement.
Only install the light on normally inflammable or
non-inflammable surfaces. Excessive heat can
result in a fire.
To prevent burns, ensure that the light is switched
off and has cooled down before touching it.
Lamps become very hot.
Allow the light to cool down completely before
replacing a defective bulb.
Do not attach the light to a damp or conductive
substrate.
Safety notices / Preparation
Replace defective lamps with new ones imme-
diately. Use only lamps as stated in the chapter
"Technical Data". Before changing lamps, always
first remove the fuse or switch off the circuit
breaker.
The type of lamp included is not suitable for
dimmer or electronic switches.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
Safe working
Only use 220–240 V∼ LED lamps with an
GU10 socket and a maximum power of 5 Watts
(3436-025) or 220–240 V∼ LED lamps with an
E14 socket and a maximum power of 5.5 Watts
(3435-024L).
The outdoor light is splash-proof.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Drill bit
- Side cutting pliers
- Ladder
GB 7