CleanCraft HDR-H 108-20 Bedienungs- Und Wartungsanleitung Seite 22

• Turn the high pressure cleaner on again by turning the master switch (1) to
• Select the temperature required using the temperature adjustment knob (41).
• Press the cleaner gun lever (22) and check the nozzle spray is even without dripping.
• If necessary, adjust the pressure using the knob (8). Turn it clockwise to increase the pressure; turn it
anticlockwise to reduce the pressure.
• You can check the pressure level on the pressure gauge (13).
• When the fuel is low, the burner will stop working and the warning light (44) will light up.
• The burner will only start working approximately 3 seconds after the cleaner gun has been opened
and will stop working when the cleaner gun is closed or after it has reached the set temperature.
• If the flame goes out, the burner will stop working and the warning light (49) will light up.
• If you want to switch from hot water operation to cold water operation, turn the master switch (1) to
the position.
The high pressure cleaners were designed in compliance with categor y II of Directive 97/23/EC
for pressure equipment (PED). The compliance with this requirement is assured by a special electronic
device that constantly checks:
• that for temperatures above 110 °C/230 °F, the pressure set is below 32 bar/464 psi;
• that for pressures above 32 bar/464 psi, the temperature set is no greater than 110 °C/230 °F.
If the above limits are exceeded, the burner stops and the warning light (48) comes on.
Steam operation will only resume if the pressure is reduced to below 32 bar/464 psi.
• Turn the high pressure cleaner on again by turning the master switch (1) to
below 32 bar/464 psi by turning the knob (8) anticlockwise.
• Set the temperature between 110°C/230°F and 140°C/284°F using the temperature adjustment
knob (41).
• Press the cleaner gun lever (22) and wait for steam to be produced.
• If the burner stops working during use of the cleaner and the warning light (48) lights up, turn the
knob (8) anticlockwise to lower the pressure below 32 bar/464 psi.
• You can check the pressure level on the pressure gauge (13).
• When the fuel is low, the burner will stop working and the warning light (44) will light up.
• The burner will only start working approximately 3 seconds after the cleaner gun has been opened
and will stop working when the cleaner gun is closed or when it reaches the set temperature.
• If the flame goes out, the burner will stop working and the warning light (49) will light up.
The Manufacturer recommends the use of detergents which are at least 90% biodegradable.
Refer to the label on the detergent for instructions on how to use it.
• Turn the master switch (1) to "0".
• Unscrew the cap (11) and fill the tank making sure the liquid does not spill over. We recommend using
a funnel reserved exclusively for this purpose (maximum tank capacity 16 L / 4.2 US gal). Follow the
indications on the detergent as regards the amount to use. Replace the cap.
• Turn the knob for adjusting the detergent (34) anticlockwise.
Models with box: versions: Switch the cleaner on again by turning the master switch (1) to
•
; operate the cleaner gun lever (22) to start distribution of detergent (these versions distribute
the detergent at high pressure).
Models without box: Operate the nozzle support head (30) as shown in FIG. 4a and start up the
•
22
OPERATION IN STEAM MODE
(MAXIMUM PRESSURE 32 BAR 464 PSI)
OPERATION WITH DETERGENT
and set the pressure to
or