Makita DSL800 Betriebsanleitung Seite 11

Additional Safety Warnings:
1. Do not leave the tool running. Operate the tool
only when hand-held.
2. Check that the workpiece is properly
supported.
3. Pay attention that the pad continues to rotate
after the tool is switched off.
4. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure opera-
tor safety.
5. Do not use the tool on any materials contain-
ing asbestos.
 Do not use cloth work gloves during operation.
)LEHUV IURP FORWK JORYHV PD\ HQWHU WKH WRRO ZKLFK
FDXVHV WRRO EUHDNDJH
7. Always work in well ventilated area.
8. :KHQ SODFLQJ WKH WRRO SODFH LW RQ D ÀDW DQG
stable surface.
9. When operating the tool, connect the tool to a
vacuum cleaner as much as possible to keep
the working area clean and prevent the oper-
ator from inhaling particles generated by the
operation.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
Important safety instructions for
battery cartridge
1. Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them
out with clear water and seek medical atten-
tion right away. It may result in loss of your
eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any con-
ductive material.
(2) Avoid storing battery cartridge in a con-
tainer with other metal objects such as
nails, coins, etc.
(3) Do not expose battery cartridge to water
or rain.
A battery short can cause a large current
ÀRZ RYHUKHDWLQJ SRVVLEOH EXUQV DQG HYHQ D
breakdown.
 Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge even if
it is severely damaged or is completely worn
RXW 7KH EDWWHU\ FDUWULGJH FDQ H[SORGH LQ D ¿UH
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to
the Dangerous Goods Legislation requirements.
)RU FRPPHUFLDO WUDQVSRUWV HJ E\ WKLUG SDUWLHV
IRUZDUGLQJ DJHQWV VSHFLDO UHTXLUHPHQW RQ SDFN-
DJLQJ DQG ODEHOLQJ PXVW EH REVHUYHG
)RU SUHSDUDWLRQ RI WKH LWHP EHLQJ VKLSSHG FRQVXOW-
LQJ DQ H[SHUW IRU KD]DUGRXV PDWHULDO LV UHTXLUHG
3OHDVH DOVR REVHUYH SRVVLEO\ PRUH GHWDLOHG
national regulations.
Tape or mask off open contacts and pack up the
EDWWHU\ LQ VXFK D PDQQHU WKDW LW FDQQRW PRYH
around in the packaging.
11. Follow your local regulations relating to dis-
posal of battery.
12. Use the batteries only with the products
VSHFL¿HG E\ 0DNLWD ,QVWDOOLQJ WKH EDWWHULHV WR
QRQFRPSOLDQW SURGXFWV PD\ UHVXOW LQ D ¿UH H[FHV-
VLYH KHDW H[SORVLRQ RU OHDN RI HOHFWURO\WH
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
8VH RI QRQJHQXLQH 0DNLWD EDWWHULHV RU EDWWHULHV WKDW
KDYH EHHQ DOWHUHG PD\ UHVXOW LQ WKH EDWWHU\ EXUVWLQJ
FDXVLQJ ¿UHV SHUVRQDO LQMXU\ DQG GDPDJH ,W ZLOO
DOVR YRLG WKH 0DNLWD ZDUUDQW\ IRU WKH 0DNLWD WRRO DQG
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
Important safety instructions for
wireless unit
1. Do not disassemble or tamper with the wire-
less unit.
2. Keep the wireless unit away from young chil-
dren. If accidentally swallowed, seek medical
attention immediately.
3. Use the wireless unit only with Makita tools.
4. Do not expose the wireless unit to rain or wet
conditions.
5. Do not use the wireless unit in places where
the temperature exceeds 50°C (122°F).
 Do not operate the wireless unit in places
where medical instruments, such as heart
pace makers are nearby.
11 ENGLISH