Marshall JVM410H HEAD Bedienungsanleitung Seite 2

WARNING! IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Before going any further, make sure that
your amplifier is compatible with your
mains electricity supply. If you have any
doubt, please seek help from a qualified
technician – your Marshall dealer can help
you in this respect.
MAINS INPUT & FUSE:
The specific mains input voltage rating
that your amplifier has been manufactured
for is indicated on the rear panel of the
amplifier. Your amplifier is provided with
a detachable mains (power) lead, which
should be connected to the MAINS INPUT
socket on the rear panel of the amplifier
(Rear Panel Function #13). The correct
value and type of mains fuse is specified
on the rear panel of the amplifier. NEVER
attempt to bypass the fuse or fit one of the
incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplifier is
switched off, unplugged from the mains
electricity supply and all removable
cables have been disconnected from your
equipment before attempting to move it.
IMPORTANT SET UP INFORMATION:
1. When using JVM410H head, or
JVM410C combo with an extension speaker
cabinet(s), make sure that the speaker
cabinet(s) is connected to the correct
impedance loudspeaker jack socket(s) on
the rear panel of the amplifier. See the
LOUDSPEAKERS guide in this manual for
specific information regarding impedance
matching (Rear Panel Function #19).
PLEASE READ THIS MANUAL CAREFULLY BEFORE PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
KEEP THESE INSTRUCTIONS.
ENGLISH
WARNING Failure to do the above may
damage your amplifier. When connecting
a speaker cabinet make sure that you
use a proper speaker cable. Never use a
screened (shielded) guitar cable for this
purpose.
2. Ensure that the POWER switch (Front
Panel Function #12) is set to the OFF
position.
3. Connect the supplied mains (power)
lead into the MAINS INPUT (Rear Panel
Function #13) first and then into the mains
electricity supply.
4. Ensure that the MASTER 1 and MASTER
2 controls on the front panel are set to
zero (Front Panel Function #7).
5. Plug your guitar into the INPUT jack
socket on the front panel (Front Panel
Function #1).
6. Ensure that the STANDBY switch (Front
Panel Function #11) is in the OFF position.
7. Turn the front panel POWER switch
to the ON (I) position and wait for a few
minutes before going to point 8.
8. Engage the amplifier by switching
STANDBY to the ON position.
9. Turn the volumes up to your preferred
level and your amplifier is ready to play.