Software Configuration; Starting The System; General Information - Bosch TTM 2104 Originalbetriebsanleitung

8.

Software configuration

8.1

Starting the system

1. Switch on the power supply for the measuring units
at the electrical cabinet.
 After 30 seconds, the lighting of both measuring
units must flash 3 times, and then stay lit.
"
This means that the device is ready for operation.
2. Switch on display system (PC/ Smart TV/ Tablet).
3. Start the web browser.
 The home page of the TTM 2104 software is dis-
played automatically, provided that it has been
set as the home page beforehand.
i
If the TTM 2104 software has not been set as
the home page: Enter IP address of the "Master"
measuring unit in address input box (default IP
address:
192.168.10.10).
No. Screen element Description
1 Settings Switch to the settings menu
2 Crossing Switch to crossing mode
3 Customer/ Entering customer and vehicle data.
vehicle
4 Process Switch to process display
5 Statistics Switch to statistical evaluation
6 Record Switch to crossing protocol
7 Type of tire Selection of tire type (summer/winter
tires)
Determining the starting thresholds:
see sec. 8.2.3
8 Help Link to the original operating
instructions and initial commissioning
instructions
9 Version number Displaying the software version number
10 Date / Time Displaying date and time
11 Maximum speed Displaying the allowed maximum speed
during crossing
Robert Bosch GmbH
Software configuration | TTM 2104 | 47 | en
8.2 Settings
The following tabs are available in the settings menu:
General Information, Workshop, Thresholds, Device,
Update.
8.2.1

General information

Adjust general settings.
1. Select <Settings>.
2. Enter password: ttm#admin
3. To save changes:
Select <Apply>.
No. Screen Description
element
1 Apply Saving changed settings
2 Language Language selection
Selecting the unit of measurement: mm
3 Unit of
measurement or inch
4 Vehicle Selection of vehicle movement:
movement for forwards, backwards, forwards and
measurement backwards
display
5 Display Setting the display duration of results (in
duration of seconds).
results Entering "0": measurement results are
constantly displayed until the next
crossing is started.
6 Automatic Selection of when a crossing protocol shall
printing be printed automatically:
never, below the thresholds or always
Mode selection: measurement or
7 Mode
maintenance
8 Direction of Display of measured values with selected
travel directions of travel.
|
1 691 206 005 2017-10-25