Dometic FRIGO 8882040004 Montageanleitung Seite 34

Frigo
➤ Drill mounting holes
(Ø 10 mm) to take the
drive unit.
➤ Remove the floor mat
around the drive unit.
➤ Install the drive unit in the vehicle. Use rubber dampers (2), as well as nuts M10, double
serrated lock washer and U-washers.
I
NOTE
z It may be necessary to adjust the drive unit according to the seat console.
z Ensure that the RESET switch is easily accessible when installing the control
unit.
➤ Mount battery charger (5) under the
driver's seat.
➤ Mount the control unit (4) on the rear
wall between the driver and the pas-
senger seat
.
➤ Apply the information sticker (15) to the instrument panel so that it is easily visible.
34
Mounting the drive unit