Totalizer - Kübler CODIX 552 Bedienungsanleitung

4.4

Totalizer

The totalizer adds up the instantaneous values with a sam-
pling rate of 1 per second.
Hint: The total value remains stored even after a power fail-
ure.
4.4.1 Setting up the Input Threshold for the
Totalizer
This value is always displayed with three digits behind the
decimal point.
With the setup value 0.000 (no threshold), all input values will
be processed by the totalizer.
Note: In the ranges 4 .. 20 mA and 2 .. 10 V, an interrup-
tion of the input signal can result in an undesired reduc-
tion of the totalised value since the input drops below
the smallest input signal and this could be interpreted
as a negative instantaneous value.
With the setup value >0.000 (defined threshold), all values
smaller than the set value will be suppressed.
Menu
16
Selection Enter
Select digit
Set digit
Example : 0.100