Stryker SIDNE Link Handbuch Seite 45

Guidance and Manufacturer's Declaration: Electromagnetic Immunity
SIDNE is intended for use in the electromagnetic environment specified below. The customer or the
user of SIDNE should ensure that it is used in such an environment.
Immunity Test
Electrostatic Discharge
(ESD) IEC61000-4-2
Electrical fast
transient/burst
IEC61000-4-4
Surge
IEC61000-4-5
Voltage dips, short
interruptions and
voltage variations
on power supply
input lines
IEC61000-4-11
Power frequency (50/
60Hz) magnetic field
IEC 61000-4-8
NOTE Ut is the a.c. mains voltage prior to application of the test level.
IEC 60601
test level
±6kV contact
±2,4,6kV contact ±2,4,8kV air
±8kV air
±2kV for
±0.5,1,2kV for power supply
power supply
lines
±1kV for
±0.25,0.5,1kV for input/output
input/output
lines
±1kV
differential ±0.5, 1kV differential mode
mode
±2kV
common ±0.5,1,2kV common mode
mode
<5% Ut
(>95% dip <5% Ut (>95% dip in Ut) for
in Ut) for 0.5
cycle
40% Ut (60%
40% Ut (60% dip in Ut) for 5
dip in Ut) for
5 cycles
70% Ut (30%
70% Ut (30% dip in Ut) for 25
dip in Ut) for
25 cycles
<5% Ut
<5% Ut (>95% dip in Ut) for
(>95% dip in
Ut) for 5 sec
3 A/m
Compliance Level
lines
lines
1 cycle
cycles
cycles
5 sec
Not Applicable
Electromagnetic
Environment - guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Mains power quality
should be that of a
typical commercial or
hospital environment
Mains power quality
should be that of a
typical commercial or
hospital environment
Mains power quality
should be that of a
typical commercial or
hospital environment.
If the user of SIDNE
requires continued
operation during power
mains interruptions, it
is recommended that
SIDNE be powered from
an uninterruptible power
supply or a battery.
Not Applicable
41