Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General remarks
Principle of the
TP 2000 / TP 2000
R.C.
Fig.1
The voltage from the mains is first rectified. A high-speed transistor switch chops this
direct voltage at a frequency of up to 33 kHz. The welding transformer then creates the
required operating voltage, which is rectified and delivered to the output sockets. An
electronic controller adjusts the power-source characteristic to the electrode that is to be
welded.
The unit's compact dimensions, low weight and very modest power consumption are real
advantages in its favour. Its superb ignition and welding properties, coupled with the fact
that it can also be used as a TIG welding machine, extend its range of use and applicati-
on still further.
Machine concept
The TP 2000 / TP 2000 R.C. may only be small, but it is built to function dependably
under even the toughest operating conditions. Features such as its powder-coated
sheet-steel housing, the way its controls are protected by a plastic frame, and its bayo-
net-latching connection sockets all testify to the high quality of its design. Thanks to its
carrying strap, the machine is easy to move around - both in the workshop and out in the
field.
Areas of use
Fig.2
TransPocket 2000 R.C.
TP 2000 R.C. as a manual electrode
welding unit
The TP 2000 / TP 2000 R.C. is a further
member of the new generation of welding
rectifiers. High-performance electronics
have helped create a truly unique rectifier
that weighs in at a mere 10.5 kg.
Fig.3
TP 2000 R.C. as a TIG welding unit
2
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
