General Description; Extent Of The Delivery; Description Of Function; Overview - Parkside PWS 125 E4 Originalbetriebsanleitung

GB MT
The device is not intended for any other
types of applications (e.g. grinding with
unsuitable grinding tools, grinding with a
coolant solution, grinding or cutting hazar-
dous materials such as asbestos).
The device is intended to be used by do-it-
yourselfers. It was not designed for heavy
commercial use. The tool is to be used by
adults. Children over the age of 16 may
not use the tool except under supervision.
The manufacturer is not liable for damages
caused by an improper use or incorrect
operation of this device.

General description

The illustration of the principal
functioning parts can be found
on the front and back foldout
pages..

Extent of the delivery

Carefully unpack the appliance and check
that it is complete:
- Device
- Handgrip
- Protective hood
- Chuck key
- Cutting disc
- Carbon brushes
- Instructions for use

Description of function

The angle grinder is made for cutting,
scrubbing or brushing metal. There is a
special disc for each of the separate ap-
plications. Please refer to the information
from the disc manufacturer.
Please refer to the descriptions below for
information about the operating devices.
70

Overview

1 Handgrip
2 Threads for handgrip
3 Speed regulator
4 On/off switch with switch lock
5 Maintenance coverage
6 Screw
7 Threads for handgrip
8 Cutting disc
9 Protective hood
10 Spindle stop button
11 Power plug
12 Carbon brushes
13 Chuck key
14 Mounting lange
15 Clamping nut
16 Mounting spindle
17 Compression spring
18 Carbon brush
19 Groove for compression spring
20 Connection
21 Contact shoe
22 Contact plug
23 Wire ring, guard cover ixing
24 Groove, guard cover ixing
25 Handle attachment

Technical data

Angle grinder PWS 125 E4:
Rated input voltage ....230-240 V~, 50 Hz
Power input ............................. 1200 W
Idling speed (n) ............ 3000-12000 min
Dimensions of the cutting/
roughing discs ........... Ø 125 x 22,23 mm
Thickness of the cutting/
roughing discs ....................... max. 6 mm
Grinding spindle thread .................. .M14
Thread length
-1