Warranty; Troubleshooting - Chicco Easy Touch Plus Gebrauchsanleitung

Manufacturer's Guide and Declaration – Electromagnetic Emissions
Chicco's IR forehead thermometer Easy Touch PLUS is designed to operate in the following electromagnetic envi-
ronments. The consumer or end-user should check that the thermometer is used in recommended environmental
conditions.
Emission test Conformity
RF CISPR11 emissions Grupp 1
RF CISPR11 emissions Group B

WARRANTY

This thermometer is guaranteed against manufacturing defects for a period of two years from the
date of purchase, on the condition it is used according to the instructions provided in this manual.
This warranty is not applicable when damage is caused by improper use.
If the thermometer should need repair during the warranty period, please send it, together with
proof of your purchase (compulsory requirement) to the distributor who will repair or replace the
device free of charge.
This warranty does not grant the purchaser any particular legal rights. Purchasing rights may vary
from country to country, and nation to nation.
Error Message
Error 5-9, the system is not wor-
king properly.
The battery has run low and
cannot take any temperature
readings.
Readings taken before the applian-
ce is ready.
The appliance displays a rapid
change in the room temperature.
The temperature reading is not
within the foreseen range of from
10°C to 40°C (50°F - 104°F).
Electromagnetic environment - Guide
Chicco's IR forehead thermometer Easy Touch PLUS uses RF power for
its internal functions only. The RF emissions are therefore very low and
presumably do not generate any form of interference with electronic
devices in the vicinity.
The thermometer is suitable for use in every room or domestic en-
vironment, and in rooms directly connected to a low voltage public
network powering buildings used for domestic purposes.

Troubleshooting:

Problem
Remove the battery, wait one minute, replace it and switch
it back on. If the message appears again, please contact your
retailer for further assistance.
Replace the battery.
Wait for the icons to stop blinking before using the appliance
Place the thermometer in a room for at least 30 minutes with
a temperature of from:
10°C to 40°C (50°F-104°F).
Place the thermometer in a room for at least 30 minutes with
a temperature of from:
10°C to 40°C (50°F-104°F).
20
Solution
If th
this
plia
pro
REF
Rad
Ind
MT
Ind
Dis
Art
Via