Connecting The Appliance To The Power Supply - hanseatic HSBS17990WETA2I Gebrauchsanleitung

Page EN-38 Start-up
Connecting the appliance to
the power supply
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if
it shows visible signs of damage,
–
e.g. the power cord is defective,
it starts smoking or there is a smell
–
of burning,
it makes unfamiliar noises.
–
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our service de-
partment (see page EN-41).
Never connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Do not kink or pinch the mains cable or
lay it over sharp edges. This can result
in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fire and property damage.
Only connect the appliance to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may make its way into
the cooling circuit.
If possible, do not tilt the refrigerat-
■
ing appliance horizontally.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to flow
back into the compressor.
• Insert the mains plug into an easily acces-
sible socket (220–240 V~/50 Hz).
When you open one of the appliance doors,
the interior of the appliance is lit up.
You will find all important information
about operation from page EN-13.