Operation; Stand-By Mode; Switching The Appliance On And Off; Locking/Unlocking The Control Panel .En - hanseatic HSBS17990WETA2I Gebrauchsanleitung

Operation

Before getting started
• Read chapter „Safety" from page EN-6
and all the safety notices.
• Set up and connect the appliance as
described in chapter „Start-up" from
page EN-34.

Stand-by mode

If no button is pressed for 30 seconds, all sig-
nals on the control panel will switch off and
the control panel will lock automatically.
To make the indicators light up again,
• push any button.
• open a door.
To unlock the control panel, press and hold
the LOCK/UNLOCK button (22) for 3 seconds
until the symbol lights up.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may make its way into
the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting.
Operation
Switching on
1. Insert the mains plug into an easily acces-
sible socket (220–240 V~/50 Hz).
– When you open one of the appliance
doors, the interior of the appliance is lit up.
– The compressor starts to work, the re-
frigerant flows through the pipes and a
quiet humming sound can be heard. The
appliance is switched on.
2. If the appliance is making unusual noises,
check that it is stable and remove any ob-
jects that may be on top of it.
Switching off
1. Pull the mains plug out of the socket.
– The signals on the control panel go out.
– When you open one of the appliance
doors, the lights inside the appliance (5)
remain switched off.
– The compressor is switched off. The ap-
pliance doesn't refrigerate.
2. Empty the appliance and clean it (see
„Care and maintenance" on page EN-28).
3. Leave the appliance doors slightly open
to prevent mould from forming.
Locking/unlocking the control
panel
The fridge-freezer is protected against un-
intentional changes in settings. The
bol lights up on the display. If any button is
pressed, you will hear a beeping sound and
the signal (23) will flash. The control panel
is locked.
The DISPENSER button (25) is not affected
by the lock function.
Page EN-13
(23) (22)
sym-