Dispensing Cold Water; Overheating Can Result In Damage To - hanseatic HSBS17990WETA2I Gebrauchsanleitung

Page EN-24 Removing cold water and ice
L
/4 .5
M a x
M in
1. Open the lid and fill the water tank (13)
with cold, fresh tap water so that the wa-
ter level is above the "Min" mark but be-
low the "Max" mark (4.5 L).
2. Close the lid.
3. Slide the water tank back into the slot fully
to ensure it is properly inserted.

Dispensing cold water

NOTICE
Risk of damage!

Overheating can result in damage to

the ice maker.
Do not dispense water from the cold
■
water outlet for longer than 3 minutes
at a time.
(24)
1. To dispense cold water, press the DIS-
PENSER button (25) repeatedly until the
symbol (24) lights up on the display.
2. Push the vessel against the dispenser
guide (35).
Cold water will begin to pour into the vessel.
3. Remove the vessel from the dispenser
guide to stop the flow of water.
Please note that the symbol
ter 150 days and start flashing after 180 days
to remind you to clean the water tank (14).
After cleaning the water tank, you can turn
off the symbol by pressing and holding the
DISPENSER button for 3 seconds.
(25)
(35)
will light up af-