Switch On The Ice Maker; Dispensing Crushed Ice - hanseatic HSBS17990WETA2I Gebrauchsanleitung

Page EN-26 Removing cold water and ice
If the , or
pear on the display, press the DIS-
PENSER button (25) once. The signal
will appear on the display.

Switch on the ice maker

If you are dispensing cold water or ice for the
first time or following an extended locking of
the ice maker, you need to prepare the appli-
ance as follows:
1. Remove the locking box (34) from the ice
dispenser (2).
Store the locking box in a safe place in case
you need to lock the ice maker in future.
2. If required, press the LOCK/UNLOCK but-
ton (22) to unlock the control panel.
3. Press the ICE OFF button (30) to unlock
the ice maker.
4. Dispense cold water from the ice maker
until the water flowing from the ice and
cold water outlet (36) is free of bubbles. In
doing so, the ice maker should be flushed
with at least 5 litres of water. Proceed as
described in the following chapter. Do not
use the water you have used to rinse the
machine.
signal does not ap-
(34)
(2)

Dispensing crushed ice

(26)
1. Press the DISPENSER button (25) re-
peatedly until the symbol (26) appears
on the display.
2. Hold the vessel as closely as possible
to the opening for the ice (36), in order
to avoid crushed ice from spraying out
around the sides of the vessel.
3. Push the vessel against the dispenser
guide (35). The vessel will be filled with
crushed ice.
4. To stop the flow of ice, pull the vessel
back slightly from the dispenser guide.
Keep holding the vessel under the ice
outlet for another 2 seconds to catch any
falling ice.
(25)
(36)
(35)