Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E N G L I S H
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
Fitting a mains plug to 115 V units
(U.K. & Ireland only)
• The plug should be fitted by a competent person.
If you are in doubt, contact an authorized
D
WALT repair agent or a qualified electrician.
E
The wires are coloured according to the following code:
live = brown
neutral = blue
• Do not connect the blue or brown wire to the
earth terminal in the plug. Connect as follows:
brown to terminal marked 'L'
blue to terminal marked 'N'
The plug fitted should be comply with BS EN 60309
(BS4343), 32 Amps.
Always ensure that the cable clamp is
correctly and securely fitted to the
sheath of the cable.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data).
The minimum conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely. Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
28
2
.
Cable rating (Amperes)
6
10
15
20
25
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
.
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Connecting to the mains
The mains supply to be used for this machine must
be equipped with a 16 A cut-out fuse with time delay.
Voltage drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than 0.25 ø, disturbances are unlikely to occur.
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Bench mounting (fig. A)
Mounting holes (9) have been provided to facilitate
bench mounting.
Removing and fitting a cutting disc (fig. B1 - B3)
• With the arm in the rest position, use the lip (15)
to slide the guard (4) back. Leave the guard
retracted (fig. B1).
• Press and hold down the spindle lock (6) (fig. B2).
• Rotate the cutting disc (5) until it locks.
• Using the Allen key (14), remove the bolt (16) by
turning counterclockwise and then remove the flat
washer (17) and the retaining flange (18) (fig. B2).
• Check that the spacer (19) is in place against the
flange (20).
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
60
6
10
15
20
25
-
-
-
6
6
6
6
15
15
20
-
Werbung
Inhaltsverzeichnis
