Prior To Operation - DeWalt DCS391N Bersetzt Von Den Originalanweisungen

ENGLISH
Shoe Adjustment for 90° Cuts
(fi g. 1, 5)
1. Adjust the saw to 0° bevel.
2. Retract the blade guard using the lever (f) and
place the saw on the blade side.
3. Loosen the bevel adjustment knob (j).
4. Place a square against the blade and shoe to
adjust the 90° setting.
5. Turn the calibration screw (q) so that the shoe
will stop at the proper angle.
6. Confirm the accuracy of the setting by checking
the squareness of an actual cut on a scrap
piece of material.
Rip Guide Installation and Usage
(fi g. 6)
Ripping is the process of cutting wider boards into
narrow strips, cutting the grain lengthways. Hand
guiding is more difficult for this type of sawing and
the use of the rip guide is recommended.
WARNING: For your own safety, read
the instruction manual before using
any accessory. Failure to heed these
warnings may result in personal injury
and serious damage to the saw and
accessory. When servicing this tool, only
use identical replacements.
ASSEMBLY
1. Loosen the rip guide knob (o).
2. Insert the rip guide (p) as shown in figure 6.
3. Tighten the rip guide knob (o) securely.
Use the supplied rip guide only with the DCS391
circular saw. Use of this rip guide with other saws
may increase the risk of kickback and injury.
Before making a cut, ensure the rip fence is securely
fastened to the tool.
After installing the rip guide on the saw or after
moving the guide to change the rip width setting,
check the operation of the lower guard before
starting the saw and making a cut to make sure that
the rip guide does not affect proper guard operation.
Replacing the Saw Blade (fi g. 7)
1. Engage the blade lock button (k) and unscrew
the blade clamping screw (h) by turning
clockwise using the hex key supplied with the
tool.
2. Retract the lower blade guard (g) using the lever
(f) and replace the blade. Reinstall the washers
(r, s) in the correct position.
44
3. Check the direction of rotation of the blade.
4. Thread on the blade clamping screw (h) by
hand to hold the washer in position. Turn anti-
clockwise.
5. Press the blade lock button (k) while turning the
spindle until the blade stops rotating.
6. Tighten the blade clamping screw firmly using
the hex key.
Blades
WARNING: To minimize the risk of
eye injury, always use eye protection.
Carbide is a hard but brittle material.
Foreign objects in the workpiece such
as wire or nails can cause tips to crack
or break. Only operate saw when proper
saw blade guard is in place. Mount
blade securely in proper rotation before
using, and always use a clean, sharp
blade.
WARNING: Do not cut ferrous metals
(steel), masonry, glass, masonry-type
planking, cement board or tile with this
saw.
Do not use abrasive wheels or blades. A dull blade
will cause slow inefficient cutting, overload on
the saw motor, excessive splintering, and could
increase the possibility of kickback.
If you need assistance regarding blades, please call
contact your local service center listed on the back
of the manual.

Prior to Operation

• Make sure your battery pack is (fully) charged.
• Make sure the guards have been mounted
correctly. The saw blade guard must be in
closed position.
• Make sure the saw blade rotates in the direction
of the arrow on the blade.
• Do not use excessively worn saw blades.
OPERATION
WARNING: Turn unit off and
disconnect battery pack before
installing and removing accessories,
before adjusting or when making
repairs. Lock the trigger switch when
the tool is not in use and when storing
the tool.