Interface Connection (Usb - B); Interface Features; Connection Power Supply - Lenz Digital Plus LZV200 Betriebsanleitung

Now you can switch off the central unit again and remove the stick.
Make sure that you do not switch on the unit again until the lower red
LED on the front has gone out.

5.8 Interface connection (USB - B)

With its integrated USB interface, the LZV200 offers the option of
connecting a PC directly via USB. The interface can be used for PCs
with Windows 7© operating system or higher.
Your computer needs a free USB interface for the operation of the
USB interface. To connect the LZV200 to your computer, use a USB
connection cable with A and B plugs.
Before connecting the USB interface, please switch on the computer
so that the computer recognizes the new hardware and the driver can
be installed. Plug the USB "B" connector into the jack labeled "USB".
Connect the USB "A" plug to a free USB port on your computer.
The first time the LZV200 is connected to the computer, the required
driver is automatically downloaded from the Internet.
5.8.1

Interface Features

The PC interface integrated in the LZV200 is technically identical to
the following

the "USB interface" (Art. 23150) and

the USB part of the "LAN/USB interface" (art. no. 23151).
This means that any PC software for these devices can be used
immediately and unchanged with the LZV200.
Of course, the "CV Editor" can also be used with the LZV200.
The baud rate is set to 57600 bps.
A protocol description for communication between PC and the
LZV200 interface can be downloaded from our website.

5.9 Connection power supply

As an alternative power connection you can use a commercially
available power supply. The pin diameter must be 2.5 mm. Plus and
minus do not have to be observed. The power supply should supply
min. 2.5 A and max. 5A.
The following values are permissible as input voltage:
41
E