Connecting Elements - FLORABEST 1226L4 Montage- Und Betriebsanleitung

Connecting elements

Assembly
CAUTION!
For your safety the heads of the screws should
always point outward, otherwise injuries can
occur.
Only firmly tighten all screw connections after
assembly is concluded, otherwise undesired
material tension can occur.
1. Insert an ash collecting sheet holder (J) and a
stand reinforcement (H) above each upper end
of a stand element (I + O). Mount the stand
elements (I + O) on the fire bowl (G) in the
arrangement shown. Use the M6x30 screws
and Ø6.4xØ18 diameter washers.
2. Hook the front tab of the wire holder (L) into
the lower bore of the stand element (O).
Guide the ends of the wire holder (L) through
the lower bores in the stand elements (I).
Mount the wheels (K) with Ø8xØ18 diameter
washer and M8 nuts to the ends of the wire
shelf (L).
3. Screw two of the handles (A) onto the fire bowl
(G) via the M6x10 screws, Ø6.4xØ12 washers,
and M6 nuts. Fasten the hood holder (D) to
the handle (A) on the inside of the hood (C)
via M6x10 screws, Ø6.4xØ12 washers, and M6
nuts.
4. Fasten the vent plates (B) on the fire bowl (G)
and on the hood (C) from the outside with
M4x10 screws, Ø4.2 washers, and M4 nuts.
M6x30 M4x10 M6x10
3x 2x 6x
5.
6.
The grill must be placed on a stable and firm
substrate during operation, otherwise it can
tip over.
Ø4,2 Ø6,4xØ12 Ø6,4xØ18
2x 6x 3x
Clamp the ash collection sheet (N) into the ash
collection sheet holder (J) between the stand
elements (I + O).
Insert the charcoal grate (F) and the grill
element (E) in the fire bowl (G). If needed place
the charcoal divider (P) on the charcoal grate (F).
Note the comments on the following pages.
WARNING!
M4 M6 M8 Ø8xØ18
2x 6x 2x 2x
5