Responsibilities, Organizational Measures; Responsibilities Of Operator; Responsibilities Of Personnel; Product-Specific Hazards - Mettler Toledo InPro 86 0i-Serie Bedienungsanleitung

InPro 86X0 i
a
h
a
h
© 12 / 2018 Mettler-Toledo GmbH, CH-8902 Urdorf
2.5

Responsibilities, organizational measures

2.5.1 Responsibilities of operator

– The operator is under obligation only to permit persons to work with InPro 86X0 i sensors,
who are familiar with the basic requirements of work safety and accident prevention, and who
have been instructed in the handling of the sensor. This instruction manual serves as the
basic document.
– In addition to the instruction manual there are also generally valid legal and other binding
regulations for work safety and accident prevention as well as for environmental protection,
and these must be provided by the operator and instructed to personnel using the sensors.
– The operator/user must be fully aware of safety and potential danger factors during work with
the sensor and this awareness must be checked by the operator at regular intervals.
– Measures must be taken to ensure that the sensor is only operated in a safe and fully
functional condition.
Caution! Before the sensor is put into operation, the operator must have already clarified
that use of the sensor in conjunction with the other associated equipment and resources
is fully authorized.

2.5.2 Responsibilities of personnel

– All persons whose duty it is to operate the sensor are under obligation to read chapter 1
"Introduction" and chapter 2 "Safety" as well as the warning notices in this instruction
manual.
– In addition to the instruction manual, generally valid legal and other binding regulations for
work safety and accident prevention must be adhered to.
– Any method of working which is doubtful from a safety perspective and which exceeds the
operation according to regulations must be omitted.
Notice: Before every start-up, the sensor must be checked for:
– damage to the connections, fastenings, etc.
– leakage
– perfect functioning
– authorization for use in conjunction with other plant equipment and resources.
Caution! A defective sensor may neither be installed nor put into operation. Faulty
containment or installation out of conformance with regulations and instructions can lead
to the escape of medium or to pressure surges (explosion), potentially harmful both to
persons and to the environment.
2.6 Product-specific hazards

2.6.1 Manipulation of and maintenance work on the sensor

Notice: Before dismantling the sensor or commencing any maintenance work on it,
ensure that the equipment in which the sensor is installed is in a safe condition (depres-
surize, no explosion risk, empty, rinse, vent, etc.).
It is principally necessary to wear personal protective outfit such as protective goggles and cloth-
ing.
9
InPro 86X0 i
30 421 372 C