Citizen CBM-292 Bedienungsanleitung Seite 50

ESC ∗ m
n1
[Function]
[Code]
[Range]
[Outline]
m(Hex) Mode
0 8-dots single density
1 8-dots double density
20 24-dots single density
21 24-dots double density
[Caution]
n2 [ d ] k
Specifying the Bit Image Mode
<1B>H<2A>H<m><n1><n2> [ <d> ] k
{m= 0, 1, 32, 33
{0 ≤ n1 ≤ FF(Hex)}
{0 ≤ n2 ≤ 03(Hex)}
{0 ≤ d ≤ FF(Hex)}
{k = n1 + FF(Hex) × n2
{k = (n1+ FF(Hex) × n2) × 3}
According to the number of dots specified in n1, n2, specify the bit image of mode
n.
• The No. of dots printed is divided by 256, whose quotient is taken as n2 and
residualas n1.
• The total no. of dots printed in the bit image is equal to n1 + (256 x n2).
• When bit image data have been input in excess of dot position of one line(448 dots) ,
the excess data are discarded.
• d is bit image data, the bits subject to printing are taken as "1" and those not as "0".
• The bit image modes specified by m are shown as follows:
Vertical Direction
No. of Dots
8
8
24
24
• When the values set in m (bit image mode) are out of the above range, the data
following after n1 is processed as normal printing data.
• After completion of bit image printing, printer returns to normal data processing
mode.
bit image mode (See the table below.)}
(m = 0, 1)
(m = 32, 33)
Dot Density
67 DPI
67 DPI
203 DPI
203 DPI
49
CBM-292/293 User's Manual
Horizontal Direction
Dot Density Max. No. of Dots
101 DPI
203 DPI
101 DPI
203 DPI
288
576
288
576
CITIZEN