Initial Commissioning; Nawi Application - HBM DWS2103 Kurzanleitung

10
When properly connected with shielded cables, the DWS2103 complies with
the relevant European standards and carries the CE mark.
A formatted SD card with the parameters of the factory setting is inserted in
the device.
Mechanical dimensions are described in chapter 12 (page 34 ) and mounting
information in chapter 3, page 8 .
Subsequent sub-chapters provide an overview of the sequence of steps that
need to be taken to commission the scale, depending on the application:

• Initial commissioning

• As a component of a non-automatic scale (NAWI)
This overview includes information on the respective chapters in this Opera-
ting Manual.
1)
NAWI – non automatic weighing instrument
4.1 Initial commissioning
• Mounting the device, Chapter 3 (page 8)
• Connecting the digital load cell(s), Chapter 5 (page 11) and 5.4 (page 16)
• Connecting the supply voltage, Chapter 5 (page 11) and 5.5 (page 16)
• Connecting the serial connections, Chapter 5 (page 11), 5.8 (page 18) up
to 5.14 (page 19)
• Switching on the device, Chapter 7.1 (page 23)
• Configuration of the load cells, Chapter 7.2 (page 24)

4.2 NAWI application

• Mounting the device, Chapter 3 (page 8)
• Connecting the digital load cell(s), Chapter 5 (page 11) and 5.4 (page 16)
• Connecting the supply voltage, Chapter 5 (page 11) and 5.5 (page 16)
• Connecting the serial connections, Chapter 5 (page 11), 5.8 (page 18) or
5.9 (page 18)
• Switching on the device, Chapter 7.1 (page 23)
the following steps are described on the system CD:
• Calling the parameter menu via the hidden key
• Enabling all menu functions
HBM
³ Chapter 4.1 (page 10)
1)
A2936-1.0 en/de
DWS2103